Results 1 to 7 of 7
  1. #1
    Master of past & present Shamino's Avatar
    Join Date
    Feb 2001
    Location
    The Abyss
    Posts
    13,450

    Memory Voltage Pencil Mods: Foxconn C51XEM2AA & Gigabyte 965P DQ6

    DDR2 Memory chipsets have matured and overclockers are starting to see DDR2 Memory sticks respond and scale very well with increased voltages. What was more than enough in the past seems limiting now. With just a sharpened pencil, you can take matters into your own hands... Voltage Mod your AM2 Foxconn C51XEM2AA and Intel Conroe supporting Gigabyte 965P DQ6!
    http://sg.vr-zone.com/?i=3765

  2. #2
    Newbie of Past & Present yantronic's Avatar
    Join Date
    Nov 2004
    Location
    Paid Accomodation
    Posts
    22,897


    Vdd is on FB3 of ISL6537 on DQ6 for 2+ V.

  3. #3
    Eldonko
    Guest
    Hey guys, sorry to bump an old thread but I have a question. When measuring vdimm using measure point as outlined below in pic, I am getting a big difference compared to bios. For example 2.3v BIOS = 2.08v DMM.



    I was about to add the trimpot but I need to figure out what the voltage is for sure. Stock vdimm = 1.8v correct?

    Thanks!

  4. #4
    Master of past & present Shamino's Avatar
    Join Date
    Feb 2001
    Location
    The Abyss
    Posts
    13,450
    Quote Originally Posted by Eldonko
    Hey guys, sorry to bump an old thread but I have a question. When measuring vdimm using measure point as outlined below in pic, I am getting a big difference compared to bios. For example 2.3v BIOS = 2.08v DMM.



    I was about to add the trimpot but I need to figure out what the voltage is for sure. Stock vdimm = 1.8v correct?

    Thanks!
    yes
    is which ground point did u connect ur multimeter black tip to?
    is ur meter running low on battery

  5. #5
    Eldonko
    Guest
    I tried with 2 different DMM, both gave same result. For ground I am using a screw that is holding the board down to an alumi tray. Did you find measured vdimm is lower than bios vdimm or am I grounding improperly or something?

    Thanks for the reply.

  6. #6
    Master of past & present Shamino's Avatar
    Join Date
    Feb 2001
    Location
    The Abyss
    Posts
    13,450
    cant remember maybe yea
    just up it one notch andf if voltage read goes up to im sure u're fine

  7. #7
    FeloCaR
    Guest
    hi sham, do you know whats the max voltage you can give to mem with this mod (using 20k vr)?? Or its just for making 2.5v get stable?